|
OS Giken Twin Plate Clutch Install |
|
Page 5 of 5
Now you need to install the tranny.
Sorry, we didn't get any pics because our hands were full.
Next, we installed a URAS tranny mount.
Here is the slave cylinder installed with a new stainless clutch line. You should remove the clutch damper/loopback at this point. That is outlined in another tech page. Takamotorsports sells a nice stainless clutch line. Just tightening things up...
Last thing you need to do is adjust the clutch pedal.
It most likely will not disengage the clutch fully until you do this.
Your new clutch should make a slight jingle when its pressed to the floor.
If it makes no sound, it probably needs adjusting.
As the clutch breaks in, the jingle will get louder.
It should jingle whenever you hold the pedal down.
(some say this is annoying, I think its cool!)
<< Start < Prev 1 2 3 4 5 Next > End >>
|
Tech 
